This code initializes GPIO pins for controlling LEDs connected to...

May 12, 2024 at 03:18 PM

void Led_Init(void) { GPIO_InitTypeDef GPIO_Initure; LED_CLK(); GPIO_Initure.Pin = LED1_PIN | LED2_PIN | LED3_PIN | LED4_PIN | LED5_PIN | LED6_PIN; GPIO_Initure.Mode = GPIO_MODE_OUTPUT_PP; GPIO_Initure.Pull = GPIO_PULLUP; GPIO_Initure.Speed = GPIO_SPEED_FREQ_LOW; HAL_GPIO_Init(LED_PORT, &GPIO_Initure); LED_NBR_OF();LED_NBY_OF();LED_NBG_OF(); LED_DXR_OF();LED_DXY_OF();LED_DXG_OF(); }

This code initializes GPIO pins for controlling LEDs connected to the microcontroller. It sets the pins for LED1 to LED6 as output pins with push-pull mode, pull-up configuration, and low speed. It then initializes the GPIO ports with the specified configuration and turns off all the LEDs by calling various LED off functions.

Generate your own explanations
Download our vscode extension
Read other generated explanations

Built by @thebuilderjr
Sponsored by beam analytics
Read our terms and privacy policy
Forked from openai-quickstart-node